Have you facing laptop restart after the Blue Screen of Doom?
In the event that the blue screen flashed and your laptop rebooted consequently before you had sufficient time to read anything,
Essential point: Blue Screen of Death investigating steps.
It may take your some hours to repair Blue Screen of Death, depend on blue screen code.
1. Think what you have done just before appearance of blue screen. That will definitely help you to find reason and solution.
Did you simply install any application program any hardware, update windows, and any driver or software update and so on. If so, fix the change you made and test again for the STOP Error. Some solutions are:
- Boot with “Last Known Good Configuration” to fix registry and driver changes
- Use “System Restore” option
- Roll back driver to the original version.
2. Confirm that a base measure of free space is accessible on your Windows C drive. Here C drives means drive in which windows operating system install. It always advised keep at least 1 GB free space in C drive.
3. Check your PC for malwares and viruses. Some malwares can bring Blue Screen of Death, particularly ones that contaminate the expert boot record (MBR) or boot division.
Check your antivirus update, if you don’t have antivirus then first install any antivirus.
4. Apply every accessible Window packs and different updates. Microsoft consistently releases fixes and packs for their OS that may contain fixes for the reason for your BSOD.
5. Check driver for update. Most BSOD driver related so updating driver can fix BSOD.
6. Make sure the Application logs in Event Viewer for error or notices that may give more signs on the reason for the BSOD.
7. Just do hardware settings to default in Device Manager. If you set device manager at default mode then chances of BSOD’s getting lesser.
8. Just do BIOS settings to their default levels.
9. Verify every inward link, cards, and different segments, hardware are installed and configured appropriately. Hardware that is not set up properly can bring Blue Screen of Death so try to resetting the accompanying and afterward test for the STOP message once more:
- Check and reset all inside cables
- Reset all memory modules
10. Perform tests on all hardware. It's exceedingly likely that the reason of Blue Screen of Death is any hardware failure
- Test your RAM
- Test your HDD
If a test fails, replace the RAM or HDD.
11. Begin your laptop with only essential hardware. A valuable investigating step much of the time, is to begin your PC with the base equipment important to run the working framework. On the off chance that your PC begins effectively it demonstrates that one of the uprooted equipment gadgets was the reason for the BSODs.
Find that hardware is the cause of your BSODs then solution
- substitute the hardware
- Secondly you can update the hardware's firmware.
- check Hardware Compatibility of each other.
- make sure with the brand for support information.
Find that software is the reason for your Blue Screen of Doom
Attempt this:
- Re-install the whole software.
- Update software
- Check with the designer for bolster data.
A Student of chip level laptop repairing course understand the importance of Blue Screen of Doom solution. So hope it would helpful for you.
For Detail of course read: Go for Laptop Repairing Course